A Gauge R & R (Gauge Repeatability and Reproducibility) Study carryout to ensure dimensional control for new and existing gauges. Who will conduct this study? The Quality Engineer shall be responsible for implementing this procedure. How to proceed this study…
Internal Audit checklist is used in audit process, to ensure the compliance and effectiveness of ISO 9001, TS 16919 and Quality management system. 42 Basic phases of internal audit Quality Management Systems General Documentation Requirements Quality Manual Control…
APQP (advanced product quality planning) for new product development. – Step by step procedure for implementation and process management by advanced planning tool What is purpose of APQP? APQP (advanced product quality planning) for new product development. – Step by…
Planning of service realization procedure is a systematic process to ensure the all the production and service realization activities are performing as per standard requirements. Management is responsible for assigning responsibility to a project manager or design engineer for the…
This procedure defines the requirements for documenting quality assurance activities at Organization locations and for preparing and submitting quarterly quality assurance reports that contain an overview of quality assurance activities that occurred in each quarter. Introduction to quality assurance report?…
Preventive Actions for Prevent Potential Failures – This procedure describes how the potential nonconformity are identified and actions are taken to eliminate the cause of potential nonconformity in order to prevent their occurrence. Stages of Procedures to prevent failures The…
Introduction to Customer Feedback At the initial stage of the customer feedback in customer management system. It conducting step by steps to resolve the issues related customer complaints. Once the Compliments confirm that customer requirements and or expectations are being…
System improvements, enhance the resources reliability and system value Improving critical element in system, that can improve overall performance of the system as well as possible to controls over non-conformity which raised due to unexpected causes. System improvement through Corrective…
Why Controls on measuring instruments? Controls on measuring instruments – To control, calibrate and maintain inspection, measuring and test instrument to demonstrate the conformance of product to the specified requirements. How to ensure reliability of measuring instruments? The quality inspection,…
A Waste Management Plan Checklist is document may contain the waste management planning information with verification points to easier for inspecting each management tasks associated with waste management. Introduction This article is part of the Waste Management Plan complementing the…